MulTpI-R

(The Resurrection Project)
With lots of left over parts and no desire to sell them off. I decided that it was the only logical direction was to simply find a cheap s10 to swap all my good left over parts and make it into something fun to drive. Low and behold, I found this one on ebay for $250. Couldn't pass it up!

Unhappy with the orginal solid mount design I had on the 86. Which used the stock engine brackets compressed to fit the smaller solid frame pads caused twisting and other problems. These mounts allow the motor alot lower and set back further. But the oil pan hangs very low. Im going to build a nice skid plate for it.